Jump to content

Wishin Too is back in the water


niggle
 Share

Recommended Posts

Been a while..........since the beginning of June when the gimbal bearing got a bit noisy.

I decided to have engine out for a clean up and change any corroded parts, it wasn't to bad just a new dipstick tube and repainted d0abdf6fa6fabdd4823c9a7b366deda3.jpg

I serviced the drive and freshened up the anti foul yesterday and as the engine had new anodes I changed all the ones on tabs and drive,interestingly the 2 starboard ones were worse than the port ones.Now I wonder if the boat on my starboard which always has shore power is the cause?...!!

Also my batteries were fine after 3 months of not being used or recharged

ccea792fa568e814087c5eb166fb206d.jpg

9e9f0edd21f266c8e18b0f1625d0bf30.jpg

I took her out tonight for a run at full throttle along the training bank and all was fine so i'm all good to go again

d8ac24df8b2e0d008c2eeb9214fe30f6.jpg

See you out there

Link to comment
Share on other sites

Did you know there is a 10kt speed limit in the swash/boat channel ????

 

Don't worry there are plenty of gin palaces going faster even in the harbour

 

 

Same rules don't apply to some it seems.

 

The same idiots get within spitting distance of me whilst at anchor doing 20kts. What's that all about?

Link to comment
Share on other sites

Did you know there is a 10kt speed limit in the swash/boat channel ????

 

Don't worry there are plenty of gin palaces going faster even in the harbour

Dave no excuse but 6pm and no other boats apart from the one that went by me while I was doing 10 knots,closest point I could sea trial just in case I did break down.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...